Can a 200 Amp Panel Handle an Induction Range?
Yes — in typical homes it fits with room to spare. With an induction range on 200 A service, an example 2,800 ft² home reaches about 80 A (green) with gas appliances and 95 A (green) with an electric range, dryer and water heater (NEC® 220.83).
That leaves about 120 A free in the gas home and 104 A in the electric one. In the electric home the new unit replaces the old one, so the load barely changes. Your own numbers — home size and which appliances are electric — decide the result.
Two example homes
Gas appliances
2,800 ft², gas cooking, drying and water heating, adding a induction range
Green · 80 A of 200 AElectric appliances
2,800 ft², electric range, dryer and water heater, adding a induction range
Green · 95 A of 200 AWorked example · NEC® 2023 220.83(A)
2,800 ft², electric range, dryer and water heater, 200 A service, adding a induction range
| General lighting and receptacles: 2,800 ft² × 3 VA | 8,400 VA |
| Kitchen small-appliance circuits: 2 × 1,500 VA | 3,000 VA |
| Laundry circuits: 1 × 1,500 VA | 1,500 VA |
| Dishwasher | 1,200 VA |
| Central AC, 4 ton (heating/cooling) | 9,600 VA |
| New induction range | 12,000 VA |
| Electric dryer | 5,000 VA |
| Electric water heater | 4,500 VA |
| First 8,000 VA at 100% | 8,000 VA |
| Remainder 37,200 VA at 40% | 14,880 VA |
| Demand ÷ 240 V | 95.3 A of 200 A |
Green — fits with room to spare · 105 A free
Free download
Panel Capacity Worksheet
A printable sheet to map your panel, list your big appliances and ask an electrician the 10 questions that matter before a quote.
Questions
Does an induction range use more power than an electric range?
For the load calculation they’re treated the same: by nameplate, or 12,000 VA by default. Replacing an electric range with induction usually changes little; replacing gas adds a new load.
Can I get induction without a 240 V circuit?
Some 120 V induction ranges with built-in batteries exist and plug into a standard outlet. Check the manufacturer’s circuit requirements before you buy.
Why is the calculated load lower than my breakers add up to?
Breakers are sized to protect wires, not to describe what runs at once. The NEC® load calculation starts from floor area, kitchen and laundry circuits and appliance nameplates, then applies demand factors.
How accurate is this estimate?
It follows the NEC® 220.83 method with the numbers you enter. Defaults stand in for unknown nameplates, so treat it as an estimate; a licensed electrician and your inspector make the final call.